What experiences and insights do professionals in the field of film and television production have when reviewing their careers? Who is leading the rigid-flex board industry? What are the positions that you are familiar with that you can apply for? Enroll in everything in the future? Here is a professional term for an analyst for a specific position, and I will give you some simple Q&A.
Have you ever invested a lot of effort in your PCB design team to meet the needs of your engineers? But for our engineers, have you ever had any deficiencies in your product capabilities and experience, and did not fully understand complex knowledge or feelings? If it is in the drawing, it is recommended to have an analyst, as our DFM expert is very good.
Schematic design is the process of determining the rationality of component placement, which is an efficient and accurate division of PCB and component drawing.
The PCB design schematic design is divided into physical structures, mainly including the following parts to complete the design. These parts are the following parts, and each part is a very important design.

It includes a main diagram, and the design requirements of the main diagram mainly include the following parts, which we have included in the following content.

Regarding guidelines (1), sometimes we also make them into a main image and then manufacture the subsequent design.
For example, should we also design a schematic diagram for the following diagram? If it is the following content, we can also make it into a main diagram.
Some factories should do pattern screen printing design, including through hole opening, through hole blockage, interlayer short circuit, etc.
When designing circuit boards, while ensuring complete functionality, and based on the actual functions to be achieved, while minimizing insertion losses, the probability of circuit errors, and high current output capacity, special attention should be paid to the current distribution wiring when designing components. The isolation current size or the physical size of the current size should be indicated.
Do not think that pulling the decoupling capacitor additionally can provide feedback and enable the device to operate at the full peak current level. This will immediately affect the performance and reliability of the device, while standard errors caused by the capabilities of other devices are within the allowable range. Based on this idea, it is recommended to choose capacitors of 01uF and 01uF.
Choosing a 47uF capacitor requires considering this factor to ensure that the capacitor is' held higher '.
Parallel capacitors and Y capacitors are suitable structures that can improve voltage resistance. Mainly used in low resistance situations.
The withstand voltage of a capacitor depends on the insulation distance between wires and also on its polarity. This depends on the creepage distance and electrical clearance.
If the distance between two wires is the same, the capacitance connected to the circuit can reduce the amount of charge passing through the primary side, rather than passing through the circuit on the primary side.
Figure 5 shows the charging current of each capacitor connected to Y capacitor C and Y capacitor E.