What is the role of the nickel plating process for PCB circuit boards? What are the advantages? What are the steps in the production process of Electronic Manufacturing Services. Difficulties in PCB circuit board nickel plating process: 1. PCB board nickel plating process refers to adding a small amount of water nickel to the copper surface before the PCB circuit board is required or applied to make nickel plating, and uniformly covering the nickel on the copper surface using a continuous method. 2. The pollution on the copper surface of PCB board refers to the smoothness of the metallized holes, but some areas cannot be plated. This type of pollution is called interference layer or delamination. The cause of this problem is usually referred to as "metallized hole spots or non conductive" coatings. "If there are conductive agents that prevent circuit reactions, then we should all use a copper layer. We can assume that some printed circuit boards are no longer conductive. In addition to conductive electroplating and decoration, they also have other required surface treatments. When they have the same conductive metal, they also have different surface treatments.
The surface efficiency of the insulation substrate with surface treatment that can be obtained is between 10% and 20%. The substrate has the same surface treatment and other characteristics. However, there are different surface treatments.
High hardness: If your fingers are used on a light board, please use a color test table to identify the resistance and surface quality through the circuit on the board. This can cause the circuit board to bend and be peeled off by laser in the surface area. These must not affect the quality of the circuit board at multiple points, but it can be determined that circuit board bending may be negatively affected.
In addition to being affected by bad weather, high shrinkage can affect the quality of circuit boards. Forming patterns on copper materials reduces power consumption and leads to high trace jitter. Strong heat may cause circuit boards to form circuits on rough copper materials.
You can say that circuit board bending is the initial bending. When you are impacted, bending may occur. Don't worry to avoid certain stresses. Although bending is a natural condition, it can bring devastating damage to the manufacturing industry.
Once broken, bending of your circuit board may cause many problems. The fracture is severe as it will have a significant impact on the later stage and the entire board. Bending creates more trouble as it may distort and wear, ultimately shortening the product's lifespan.
One of the most common types of bending refers to the connection along the trace at the bend and to balance the conductor. The display screen consists of two parts, one is the screen, and the other is a circular device on the screen.
The bending area of the circuit board is important because it cannot withstand static electricity during bending, which may damage all components on the device.
The bending of some circuit boards may be complex, and the problem may be complex. Circuit board bending has a significant impact on electronic factories.

When the circuit board (PCB) is bent, it is strictly prohibited to lift the components to the bending edge with external force to avoid injuring the driver and bearing it.
If the distance between components is too close, the connector may deform. Although the connector may be decoupled by relieving stress, permanent damage to the connection point may result in damage.