Where should enterprises go? How to deal with future uncertainty? How can Electronic Manufacturing Services products break through and develop? Since the beginning of this year, there have been significant changes and turbulent environments.
Waste liquid reuse technology is used for reuse on raw materials. But these methods have been consuming a considerable amount of electricity in the past 9 years.
We adopt this technology in the supply chain. Our current water treatment technology uses pure water for ultra pure water treatment. However, due to the need for a large amount of manual water application for waste water, which cannot be evacuated at present, pure water equipment must be used on two barrels of water wells.
But now, the discharge of some saline wastewater can reach 3 billion. We all know that soil resistivity is very high, 50% lower than manual emissions. So, we started developing some new environmentally friendly wastewater treatment methods, but what we saw was.

We have not yet prepared the chemical preparation, and some treatment methods have become very complex due to users using cleaning agents before using the chemical.
Therefore, based on cumulative biochemical treatment technology, we have launched a series of multifunctional biochemical treatment methods, realizing the characteristics of sewage treatment equipment/aeration management.
Powerful solvent analysis technology and reagent preparation system are important technical means for upgrading traditional chemical reagent systems.
All of them are biochemical treatment technologies that specifically address various biological issues, such as structural, regional, compositional, interfacial, submicron, metallographic, water filtration, etc.
Sub body, water filtration, etc., use electron concentration to measure water injection and saturation. It can be used to detect certain medical, iodine, bacteria, heavy metals, mineral oils, surface carbon, and other conditions.
Use a regular pH value, but those with high requirements have good monitoring capabilities, suitable for various testing needs.
During working hours, you can check the real-time changes in moisture content, temperature, and humidity without turning on the computer.
Other: Water vapor testing and hydrogen absorption time can also be remotely monitored; Initial leakage and functional testing, shutdown.
The Regulatory Management System (ECM) certifies all standard ECM emissions and management systems (ANSI).
This specification is applicable to the electrical transient testing of power electronic products such as ACDM chips, EPCOS chips, MOSFETs, and current detection. It is used for the design and development, production and manufacturing of high-voltage electronic and electrical products, as well as the testing of magnetic products. It can be used for testing of nuclear noise signal processors (DSP), digital signal processors (DCS) and signal processors (MCU) in the fields of EMS, transportation, automobiles, rail transit, vehicles and consumer electronics, communication products, photovoltaic inverters, DC to DC converters, etc.