We work with suppliers and customers to develop new processes, materials, and technologies. Some tips for rigid-flex board customers to send emails.
Mix the materials with the molding process and complete the molding process in one go, resulting in the successful molding of the product. This step involves homogenizing the process, forming in one go, and obtaining the final component and workpiece. The process has only one step compared to the first four steps, thus eliminating the conditions for manufacturing defects. Incorporating thermal conductive tape into technology and processes such as bonding, forming, inspection, cleaning, heat treatment, shaping, and quality inspection can be further developed. Cleanliness should be maintained between each process, especially when using the highest quality high-strength conductive adhesive (electronic and electronic components). The adhesive should be kept clean to avoid scattering, incomplete isolation between each process and production equipment should be avoided, and leakage and local short circuits caused by cross contamination should be avoided. In addition, high-strength anti-static can bring you the maximum economic value. The anti-static effect obtained on the silk screen.
Electrostatic "shielding" of materials such as PCB boards, copper clad plates, and components is very common, and of course, wave soldering machines can also be used to provide a reliable solution.

The ambient temperature is. 5 ° C to+40 ° C, with a relative humidity not exceeding 85% (at a temperature of 25 ° C). 2. During installation, it is generally installed according to the specified conditions (wind and sea wind speed requirement: a1000mm ± 10%).
Compared to coaxial connectors, the cost of connectors is much lower. But the cost of coaxial connectors can also be several tens of thousands.
When designing connectors, we must consider the error of the connectors. Based on normal standards, the error is the strain gauge error, which can be doubled if the error is large. If the error is small, it can be reduced by one-third. If the error is large, it can be reduced by dozens of times. But often, the structural loss of connectors caused by temperature difference is not enough.
Because temperature rise can cause deformation of the connector, but the temperature of the sensor is the main variable in the final performance. The current system principles of strain gauges, force sensors, and strain gauges are our daily work. Although the functions and limitations of most structures vary regularly to a certain extent, they are not yet in line with our actual usage range. In terms of practical use and economic operation, attention needs to be paid to unleashing our abilities and efficiency, which can be continuously pursued.
When designing, we need to consider safety regulations, which include two aspects: firstly, the performance of the system should be composed of its functions. Currently, we can implement redundant control on the system. To avoid affecting the system's functions, we need a set of safe and stable system functions; Secondly, the redundancy design of the system is fully open during operation, making it easy for future maintenance. Of course, if we need to achieve the prerequisite for redundant control of the system, we can consider the following factors: 1. The early stages of design are divided into one level and the other level is called design.