Before the etching process, the manufacturing process of aluminum printed circuit boards is basically the same as that of traditional PCB production: which printed circuit board assembly are hot products.

Place the monitor on a thermal component. However, this fluid requires a thermal management system to handle the heat sink. If it is necessary to heat up to the same heating area, but it is necessary to know that the same etching process may encounter lower levels of circuit board components, which makes the heat management system a part of a very hot problem.
Now use a mesh welding machine to heat the circuit board. Except for the output to the thermal environment, the entire heating process does not seem to be heated to lower temperatures, and only these factors will result in the entire heating process not being affected by heat or thermal power.
Within the actual operating range, maintain the temperature as low as possible to avoid damage to the circuit board due to the possibility of slight temperature rise due to heat.
The early empirical values were for each part of the heating process n, thus having the same problem, which is why we used NTC to describe the construction of specific structures.
In the construction of ordinary thermistors, they are natural resistors. Its resistance is composed of R and R2. The material and conductive material of the thermistor are metal Cr platinum. They are composed of R2. If the metal content of the resistance is low, there is no current flowing,
On ordinary thermistors, there are two or more different leads, and the shape and size of the leads are small. On thermistors, there are three shapes. They are designed as a metal that can be used for circuit temperature measurement.
Despite their significant resistance changes, they still exhibit excellent stability at high measurement currents. The resistance change of a thermistor can undergo small changes with temperature. Therefore, they can use specific names to describe their resistance changes.
This resistance usually changes with temperature. Thermistors provide high-quality resistance, and thermocouples are the best choice. Their actual range of use is the highest. They can be measured throughout the entire range, while thermistors can be measured.
A blackbody or solid resistor, usually used to connect a small resistor to a power source. When using a thermistor for indication, it can help avoid incomplete thermal images and alarms. If the number of probes is ignored due to environmental changes, others have already realized this.
If a thermistor is used for indication, the alarm pin includes providing a given voltage drop, which will indicate your position within 1 second.
The 3-channel with thermal image display function should be connected with more current and a resistive converter, which can measure 6 mA through a resistance sensor because the thermal image display is more accurate. However, this situation was found during inspection and special attention needs to be paid.

Use a multimeter to test the resistance value and minimum resistance of the red terminal. The 50 ohm relationship between VF and VCC terminals is beneficial for preventing short circuits on the opposite side and protecting the device.